Skip to content
Nexelform
Ford Parking Sensor Retaining Bracket — 3D printed replacement part, three-quarter view

NXF-008Made to order

Ford Parking Sensor Retaining Bracket

Replacement retaining bracket for a 32 mm Ford parking sensor, for bumpers where the original clip has broken.

Enquire about this partRequest a variation

Made to order. Each one is printed for the order, so enquire for the current lead time and price.

Specification

Material
PETG / ASA
Manufacturing
FDM additive manufacturing
Dimensions
32 × 31.99 × 31 mm
Colours
Black
Status
Fit-tested

CAD source: Ford Parking Sensor Bracket by Wulthan (Printables), CC-BY

Vehicle compatibility

  • Ford Various (32 mm sensor aperture)Fit-testedFits the common 32 mm Ford parking sensor body. Measure your sensor before ordering.

When the moulded clip that holds a parking sensor into the bumper aperture breaks, the sensor drops back behind the bumper skin and the system reports a fault. The bracket is sold separately by Ford only as part of a bumper assembly on many models.

This is a direct replacement retainer for the common 32 mm sensor body, printed in PETG. The sensor pushes in from the front and the bracket locates against the back face of the bumper skin.

Measure the sensor body before ordering — Ford used more than one diameter across the range.

Validation evidence

Test-fitted on the vehicle listed and confirmed by the owner. No hot-box, load-cycling or UV testing has been carried out, and no dimensional report exists beyond the measured CAD geometry.

Fitting guidance

Remove the bumper skin or reach through the arch liner, press the old retainer out, locate the new bracket on the aperture and push the sensor home from the front until it clicks.

Known limitations

Interior face of the bumper skin only. Not visible when fitted. Does not affect sensor calibration.

See our product safety & use guidance.

Related products