Skip to content
Nexelform
Ford Puma Headlight Bracket Set (4 pieces) — 3D printed replacement part, three-quarter view

NXF-007Made to order

Ford Puma Headlight Bracket Set (4 pieces)

Four-piece replacement headlight mounting bracket set for the Ford Puma — upper and lower, left and right.

Enquire about this partRequest a variation

Made to order. Each one is printed for the order, so enquire for the current lead time and price.

Specification

Material
PETG / ASA
Manufacturing
FDM additive manufacturing
Dimensions
59.1 × 48.46 × 22.8 mm (largest piece; the set contains four brackets)
Colours
Black
Status
Fit-tested

Vehicle compatibility

  • Ford Puma (2019–)Fit-testedMk2 Puma (JK). Replaces the moulded headlight mounting tabs.

Compatible OEM references

  • 2289418Ford headlight bracket reference quoted by aftermarket suppliers; verify against your own part before ordering.

OEM numbers identify the third-party parts this item is designed to replace. This is an independent Nexelform product (NXF-007), not a genuine OEM part, and no OEM endorsement is implied.

Headlight mounting tabs are the first thing to break in a minor front-end knock, and Ford does not sell them separately — the quoted fix is a complete headlight unit. This four-piece set replaces the upper and lower mounting brackets on both sides.

Printed in PETG as standard. The brackets are screwed to the headlight housing after the remains of the original tabs are cut back and the surface cleaned; use machine screws, not wood screws.

This is a repair part for a non-structural mounting point. It does not change headlight aim, and a bracket that holds the lamp in place is not the same as a correctly aimed lamp — have the alignment checked after fitting.

Validation evidence

Test-fitted on the vehicle listed and confirmed by the owner. No hot-box, load-cycling or UV testing has been carried out, and no dimensional report exists beyond the measured CAD geometry.

Fitting guidance

Cut back the broken original tab flush, clean the housing, offer the bracket up dry to check the screw positions, then fix with M4 machine screws and nuts. Check headlight alignment afterwards.

Known limitations

Headlight mounting only. Not a structural or impact-bearing part. Does not restore any crash performance the original mount contributed.

See our product safety & use guidance.

Related products